Products
Products
Contact Us
Home > Terminal Block > 3.81mm Screw 6-Pole Blue Terminal Block...
3.81mm Male Plug Terminal Block
  • 3.81mm Male Plug Terminal Block
  • 3.81mm Male Plug Terminal Block

3.81mm Male Plug Terminal Block

Pitch: 3.81 mm
Gender: Male plug
Rated current: 8.0 A (typical)
Rated voltage: 300 V AC (typical)
Contact resistance: 20 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 2500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    A 3.81 mm male plug drops into its header

    This part is the male plug of a pluggable pair: pins in a 3.81 mm grid that seat into a matching female header on the panel. The plug carries the wiring, the header stays put, and the joint comes apart for service without a screwdriver touching the panel side. The pitch is fine enough for a dense row yet wide enough that the plastic between pins still holds shape after a few matings.

    Eight amps as the pitch tightens

    Rated at 8.0 A typical and 300 V AC typical, the plug reflects the trade every terminal family makes: smaller pitch, smaller current. Its 5.08 mm sibling carries a much heavier envelope; at 3.81 mm the contact and clamp shrink with the spacing. The withstanding test still runs 2500 V AC typical, contact resistance is 20 mΩ max and insulation 100 MΩ min, across a -40 °C to +105 °C window typical.

    Orientation on a plug that can go in wrong

    A male plug in the dark behind a cabinet wants a key or at least a marking on the face. We mark pin one on the housing and the label repeats it. Plugs on this pitch are built to your drawing and tested before packing. Small batches are routine while a product is in pilot, and the same drawing carries through to the release quantity.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products