Products
Products
Contact Us
Home > Terminal Block > 2.54mm Screw-Type 4-Pole Female Green Terminal Block...
3.81mm Pluggable Male Green Terminal Block
  • 3.81mm Pluggable Male Green Terminal Block

3.81mm Pluggable Male Green Terminal Block

Pitch: 3.81 mm
Gender: Male plug
Color: Green
Material: PPS or PBT, brass
Rated current: 8.0 A (typical)
Rated voltage: 300 V AC (typical)
Contact resistance: 20 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 2500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    The plug side at 3.81 mm

    This is the male plug half of a 3.81 mm pluggable pair, in green so it reads apart from the blue screw block on the same panel. The contacts come out of the plug body and seat into a board mounted socket, so the wire stays with the removable side. That arrangement puts the wear at a part you can replace. Use it on a module that leaves the cabinet for service, where unplugging one connector is faster than landing six individual screws.

    PPS or PBT, brass underneath

    The housing is PPS or PBT with brass contacts. PPS is the choice when the panel runs warm and dimensional stability matters to the mating fit; PBT is the economical pick where the ambient is kinder. The electrical envelope is 8.0 A typical at 300 V AC typical with 20 mΩ max contact resistance, roughly 1.28 W per pole at full load. Insulation resistance is 100 MΩ min and the proof voltage is 2500 V AC typical. Ask for the plating option when the mate count is high.

    Holding the mating half in stock

    Send the socket part number from the board side and we will confirm the plug against it before quoting, because a green 3.81 mm body is not proof that the two halves key together. We keep the common counts in stock and ship them in eight working days. If you need a keyed or a polarised version, our engineers review the mating drawing in 2 to 4 hours and return the pin map with the proposal so the whole pair is ordered as one.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products