Products
Products
Contact Us
Home > Terminal Block > 2.54mm Screw-Type 4-Pole Female Green Terminal Block...
5.08mm 8-Pole Screw-Fix Terminal Block
  • 5.08mm 8-Pole Screw-Fix Terminal Block

5.08mm 8-Pole Screw-Fix Terminal Block

Pitch: 5.08 mm
Poles: 8
Material: PPS or PBT, brass
Plating: Tin or gold over nickel
Rated current: 15.0 A (typical)
Rated voltage: 300 V AC (typical)
Contact resistance: 20 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 2500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    Eight poles held down by screws

    Eight positions at 5.08 mm is a compact power distribution strip, and the screw fixation is what lets it carry that much in a short body. The wider pitch leaves room for the screw head, the clamp and the creepage path between poles, so the block can sit near a heat source without the plastic between neighbours becoming the weak point. Use the eight way where several loads leave one rail, and mark position one on the housing before the wires go in.

    Tin or gold over nickel

    PPS or PBT forms the body here, over brass contacts with a tin or gold over nickel finish. Gold does not carry more current than tin; what it does is resist oxide buildup on a contact that mates and unmates often or sits in a damp cabinet. The rating is 15.0 A typical at 300 V AC typical with 20 mΩ max, about 4.5 W of loss per pole at full load. Insulation holds at 100 MΩ min and the part withstands 2500 V AC typical.

    One drawing, one plating choice

    Tell us the mate cycle count and the cabinet environment and we will recommend tin or gold over nickel rather than leaving the choice to habit. Small free samples cover a first fit check with the actual wire and driver. Production runs leave in 10 to 12 working days from the approved drawing, with the plating called out on the traveller so the first article and the reorder are the same part, not two parts that only look alike.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products