Products
Products
Contact Us
Home > Terminal Block > 2.54mm Screw-Type 4-Pole Female Green Terminal Block...
5.0/5.08mm Plug-in Terminal Block — 2EDJKM Series
  • 5.0/5.08mm Plug-in Terminal Block — 2EDJKM Series

5.0/5.08mm Plug-in Terminal Block — 2EDJKM Series

Series: 2EDJKM
Pitch: 5.0 / 5.08 mm
Poles: 2 to 24
Material: PA66, copper alloy
Plating: Tin
Rated current: 15.0 A (typical)
Rated voltage: 300 V AC (typical)
Contact resistance: 20 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 2500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    One series, two neighbouring pitches

    The 2EDJKM series accepts both 5.0 mm and 5.08 mm spacing, which matters because those two are close enough to be confused on a drawing and far enough apart to fail a mate. The plug-in construction lets the wire side come off the board in one motion, and the range runs from two to twenty four poles. Choose the pitch from the mating header you already stock rather than from the available board space, then hold that number through the whole harness.

    PA66 and a tinned copper contact

    The body is PA66 with a copper alloy contact and a tin finish, a combination that keeps cost sensible for a general purpose power feed while still surviving a warm cabinet. The rating is 15.0 A typical at 300 V AC typical with 20 mΩ max contact resistance, roughly 4.5 W of loss per pole at full load. Insulation resistance comes in at 100 MΩ min and the proof test at 2500 V AC typical. Tin is the right finish for a contact that is landed once and left.

    Which pitch are you mating to

    Tell us the header pitch and the pole count and we will confirm the series against the mating part before anything is cut. Free samples in small counts cover a fit check on the 5.0 versus the 5.08 question, which is much cheaper to settle with a part in hand. Production runs leave in 10 to 12 working days from the approved drawing, with the pitch called out on the traveller so the two versions never get mixed in one order.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products