Products
Products
Contact Us
Home > Terminal Block > 2.54mm Screw-Type 4-Pole Female Green Terminal Block...
3.81mm Screw 6-Pole Blue Terminal Block
  • 3.81mm Screw 6-Pole Blue Terminal Block

3.81mm Screw 6-Pole Blue Terminal Block

Pitch: 3.81 mm
Poles: 6
Color: Blue
Termination: Screw
Rated current: 8.0 A (typical)
Rated voltage: 300 V AC (typical)
Contact resistance: 20 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 2500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    Six blue poles at 3.81 mm

    Blue is the identification colour on this six pole screw block, and at 3.81 mm the body sits between the fine 2.54 mm signal pitch and the heavier 5.08 mm power pitch. The screw termination is for a wire that stays landed, and the six ways give enough positions for a supply pair and a handful of control lines. Choose this pitch when the board is too tight for 5.08 mm but the current is above what a 3 A signal block was meant to carry.

    Eight amps in the middle of the ladder

    The block is rated 8.0 A typical at 300 V AC typical with 20 mΩ max contact resistance. Eight amps through that contact is about 1.28 W of loss per pole, enough that the clamp needs a proper torque and enough that the wider-than-2.54 mm spacing is doing real work for creepage. Insulation resistance is 100 MΩ min, the withstand test is 2500 V AC typical, and the operating range is -40 °C to +105 °C typical. Recheck torque after the first heat cycle.

    Colour and count in one order

    Tell us the pole count and whether the blue body is doing circuit identification or just matching an existing panel, and we will quote against that. Stock counts leave in eight working days. For a new board, our engineers review the screw access and the entry angle in 2 to 4 hours before tooling moves, because a six way block at this pitch can lose a screw driver clearance very quickly. The blue and green versions share the same footprint.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products