Products
Products
Contact Us
Home > Terminal Block > 2.54mm Screw-Type 4-Pole Female Green Terminal Block...
5.0mm PCB Screw Terminal Block — Panel Mount, 306 Series
  • 5.0mm PCB Screw Terminal Block — Panel Mount, 306 Series
  • 5.0mm PCB Screw Terminal Block — Panel Mount, 306 Series

5.0mm PCB Screw Terminal Block — Panel Mount, 306 Series

Series: 306
Pitch: 5.0 mm
Material: PPS or PBT, brass
Plating: Tin or gold over nickel
Mounting: Panel mount
Rated current: 15.0 A (typical)
Rated voltage: 300 V AC (typical)
Contact resistance: 20 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 2500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    The 306 series meets the panel

    A panel mount block moves the joint to the cabinet wall instead of the board edge, and the 306 series at 5.0 mm is built for that job. The flange carries the load when a cable is pushed in and pulled out, so the solder joints on the board do not take the strain. Check the panel cutout and the sheet thickness before ordering: the flange has to clamp the panel flat, and a cutout a fraction too large turns the mount into a loose hinge.

    PPS, PBT and a plated contact

    A PPS or PBT shell holds brass contacts finished in tin or gold over nickel, so the mechanical body and the surface can be chosen separately. The rating is 15.0 A typical at 300 V AC typical with 20 mΩ max contact resistance, about 4.5 W at full load per pole. On insulation the block holds 100 MΩ min and clears 2500 V AC typical. The operating window is -40 °C to +105 °C typical, wide enough for an outdoor cabinet in a mild climate.

    Panel cutout before tooling

    Send the panel thickness and the cutout drawing and we will confirm the flange fit before quoting, because that is the detail most likely to change on a panel mount part. Sample counts cover a first fit check against your actual sheet metal. Production leaves in 10 to 12 working days from the approved drawing, and the series number travels on the label so a reorder lands the same flange and the same plating as the first build.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products