Products
Products
Contact Us
Home > Circular & Power Connector > IP68 DC Power Socket 5.5×2.1mm Panel Mount with Wi...
M8 IP67 Waterproof 4-Pin DC Power Connector — Male Plug
  • M8 IP67 Waterproof 4-Pin DC Power Connector — Male Plug

M8 IP67 Waterproof 4-Pin DC Power Connector — Male Plug

Type: M8 circular
Positions: 4 pin
Gender: Male plug
Protection: IP67
Contact: Copper
Locking: Threaded
Rated voltage: 12 V DC
Rated current: 3 A (typical)
Contact resistance: 5 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 1500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    Four pins on a 12 V DC feed

    A 12 V DC system is where this 4 pin M8 earns its keep: LED runs, CCTV drops, vehicle accessories and small control boxes that run on a battery or a brick supply. The body is rated 12 V DC with 3 A typical current and copper contacts, 5 mΩ max contact resistance and IP67 sealing per its spec. Four positions let you carry two feeds or a feed plus a sense line through one joint. Keep the voltage ceiling in view: 12 V DC is the design point, not a family that quietly scales to mains.

    Threaded locking on a DC joint

    A threaded coupling is the right answer when the joint lives on a pole, a vehicle or anything that vibrates, because it will not back off the way a friction fit does. Torque it finger tight plus a touch; the thread is doing the holding and the O ring is doing the sealing. Insulation resistance is 100 MΩ min and withstand voltage 1500 V AC typical, with an operating window of -40 °C to +105 °C. Our wire-to-board checklist covers the strain relief that keeps cable tug off the threads.

    Copper contacts and outdoor DC drops

    Copper contacts give a low resistance path at the 5 mΩ max figure, which matters on a DC return where every milliohm is a volt the load never sees. On an outdoor CCTV or lighting drop, pair the connector with a matched gland and a drip loop, and expect 24 to 48 hours of salt spray resistance on this family as the baseline for exposed work. Standard builds leave in eight working days. Finished DC leads with the plug fitted go through our cable assembly line.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products