Products
Products
Contact Us
Home > Circular & Power Connector > M8 IP67 Waterproof 4-Pin DC Power Connector — Mal...
IP68 DC Power Socket 5.5×2.1mm Panel Mount with Wire
  • IP68 DC Power Socket 5.5×2.1mm Panel Mount with Wire
  • IP68 DC Power Socket 5.5×2.1mm Panel Mount with Wire

IP68 DC Power Socket 5.5×2.1mm Panel Mount with Wire

Type: DC power socket
Size: 5.5 × 2.1 mm
Protection: IP68
Mounting: Panel mount
Rated current: 10 A (typical)
Rated voltage: 250 V AC (typical)
Contact resistance: 5 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 1500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    Why 5.5 by 2.1 is its own interface

    The 5.5 × 2.1 mm barrel figure is not a style number: 5.5 mm is the outer sleeve and 2.1 mm is the center pin, and both dimensions decide whether a plug seats. This IP68 panel socket is rated 10 A typical at 250 V AC typical with 5 mΩ max contact resistance, and it ships with wire leads attached. Mixing 2.1 mm and 2.5 mm plugs is the classic field mistake, so mark the panel and stock one size per enclosure. The socket is the interface definition, so treat it like a drawing dimension.

    Panel mounting a sealed DC socket

    The IP68 claim on a panel socket belongs to the flange, the gasket and the torque on the mounting nut, not just the barrel. Cut the hole to the specified diameter, fit the gasket dry and tighten evenly; a compression seal that is over torqued flattens as surely as a loose one leaks. Insulation resistance is 100 MΩ min and withstand voltage 1500 V AC typical, with an operating range of -40 °C to +105 °C. Our wire-to-board checklist covers the rear strain relief for the pigtail.

    Pigtail leads and polarity discipline

    Barrel jacks carry a center pin convention, and reversing polarity on a DC feed is a fast way to meet the magic smoke. Confirm center positive or center negative at the design review, mark both the panel and the lead, and check one assembled pair before the batch ships. Free standard samples in small counts are available for exactly that check. Standard builds leave in eight working days. Custom pigtail lengths go through our cable assembly line on this insert.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products