Products
Products
Contact Us
Home > Circular & Power Connector > M8 IP67 Waterproof 4-Pin DC Power Connector — Mal...
3-Pin Waterproof PVC Connector — Male Female, 20cm Copper Wire
  • 3-Pin Waterproof PVC Connector — Male Female, 20cm Copper Wire

3-Pin Waterproof PVC Connector — Male Female, 20cm Copper Wire

Positions: 3 pin
Gender: Male and female
Wire: 20 cm pure copper
Housing: PVC, waterproof
Rated current: 10 A (typical)
Rated voltage: 250 V AC (typical)
Contact resistance: 5 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 1500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    Short 20 cm leads sold as a pair

    A 20 cm pigtail with male and female on 20 cm of pure copper is the jumper you reach for when two boards or two modules need a sealed link inside one enclosure. Three positions carry a supply pair plus a signal at 10 A typical and 250 V AC typical, with 5 mΩ max contact resistance. Ordering the pair together matters, because a waterproof PVC joint only seals when both halves are built to the same shell. Keep the leads short on purpose; the 20 cm figure is for inside a box, not for a field run.

    PVC housing and where it draws the line

    PVC is an economical, moldable housing that seals well and takes a printed marking, and it covers the -40 °C to +105 °C window listed for this body. What it is not is a flex rated jacket for a moving machine, so keep the joint in fixed installs or gentle routes. Insulation resistance is 100 MΩ min and withstand voltage 1500 V AC typical. If the route crosses an oily or high flex zone, ask about a tougher jacket on the same insert. Our wire-to-board checklist covers matching relief to the material.

    10 A through a three pin waterproof joint

    At 10 A typical the wire gauge does the work as much as the contact, so size the copper to the load and keep the strip length exact at the crimp. The waterproof claim covers the mated pair and the cable entry together; a taped entry ends the rating at the first rain. Free standard samples in small counts are available to check the mate and the seal before the release quantity. Standard builds leave in eight working days. Finished pairs go through our cable assembly line.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products