Products
Products
Contact Us
Home > Circular & Power Connector > M8 IP67 Waterproof 4-Pin DC Power Connector — Mal...
DT/DTM Waterproof Automotive Connector — 2 to 12 Pin
  • DT/DTM Waterproof Automotive Connector — 2 to 12 Pin

DT/DTM Waterproof Automotive Connector — 2 to 12 Pin

Series: DT / DTM automotive
Positions: 2 to 12 pin
Sealing: Waterproof
Application: Forklift / excavator / vehicle harness
Termination: Crimp
Rated current: 10 A (typical)
Rated voltage: 250 V AC (typical)
Contact resistance: 5 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 1500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    DT and DTM on forklifts and excavators

    The DT and DTM families are the working standard on forklifts, excavators and truck harnesses, and they earned it in mud, wash bays and winter starts rather than on a spec sheet. This waterproof series covers 2 to 12 positions, crimp terminated, rated 10 A typical at 250 V AC typical with 5 mΩ max contact resistance. If the machine already carries these housings, matching the series is usually cheaper than adapting a new footprint. The application in the brief is exactly right: heavy equipment harnesses where a connector gets grabbed with gloves and reworked in a yard.

    Crimp contacts and wedge locks

    The DT and DTM retention story is two parts: a crimped contact that gas tights onto the conductor, and a wedge lock that holds the contacts in the housing against vibration. Crimp to the recommended die, pull test one piece per lot and fit the wedge before the housing goes anywhere near the machine. Unused cavities take plugs so the seal stays honest. Insulation resistance is 100 MΩ min and withstand voltage 1500 V AC typical. Our wire-to-board checklist covers harness strain relief behind the bulkhead.

    Choosing between 2 and 12 positions

    A 2 pin DT for a lamp feed and a 12 pin DTM for a cab trunk share the design language but not the wiring plan, so count the conductors at the far end first and leave one cavity spare if the machine will grow. A rebuild rarely stalls on connector design; it stalls when the channel quotes a 6 to 12 week horizon and a full case minimum for housings that are already catalog parts. We run the same footprint on our own lines, so pilot quantities and mixed pin counts are normal and the job keeps moving. Standard builds leave in eight working days. Custom harness lengths go through our cable assembly line.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products