Products
Products
Contact Us
Home > Circular & Power Connector > M8 IP67 Waterproof 4-Pin DC Power Connector — Mal...
XT60 Solar Panel Connector — 10AWG Female Wire Harness
  • XT60 Solar Panel Connector — 10AWG Female Wire Harness

XT60 Solar Panel Connector — 10AWG Female Wire Harness

Type: XT60 connector
Gender: Female
Wire: 10AWG copper
Application: Solar / portable charge
Wire length: Customizable
Rated current: 10 A (typical)
Rated voltage: 250 V AC (typical)
Contact resistance: 5 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 1500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    XT60 in solar and portable power

    The XT60 pattern showed up in battery packs and RC power and then walked straight into portable solar, because it is compact, polarized and quick to mate with gloves on. This female harness comes on 10 AWG copper with customizable wire length, rated 10 A typical at 250 V AC typical with 5 mΩ max contact resistance and a -40 °C to +105 °C window. It suits portable charge controllers, folding panel kits and small off grid boxes. The gender is the design decision here, because XT60 pairs are keyed by shell and swapping halves on a finished kit is a rework.

    What 10 AWG carries and how it feels

    10 AWG is a flexible, low loss conductor for short power leads, and it is the right stock for a 10 A typical feed that gets coiled and stuffed in a bag. Copper strand count decides how the lead feels in the cold, so ask for fine strand if the kit gets packed often. Insulation resistance is 100 MΩ min and withstand voltage 1500 V AC typical. Our wire-to-board checklist covers strain relief at the exit so the flex lands on the jacket, not the crimp.

    Custom lengths without a reel commitment

    Solar kits order leads by the fold and the case, not by the meter, so wire length being customizable is the point of this part. State the length, the gender and the opposite termination with the inquiry and we will match the contact barrel and the jacket. Custom harness builds typically leave in 10 to 12 working days. Sample leads are fine before the full release. Our cable assembly line finishes the pair with the XT60 already fitted and tested for polarity.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products