Products
Products
Contact Us
Home > Circular & Power Connector > M8 IP67 Waterproof 4-Pin DC Power Connector — Mal...
IP68 5-Pin 45A Panel Mount Power Plug — Circular Connector
  • IP68 5-Pin 45A Panel Mount Power Plug — Circular Connector

IP68 5-Pin 45A Panel Mount Power Plug — Circular Connector

Type: H32 circular power
Positions: 5 pin
Rated current: 45 A
Protection: IP68
Termination: Screw (solderless)
Mounting: Panel mount
Rated voltage: 250 V AC (typical)
Contact resistance: 5 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 1500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    45 A through screw terminals

    At 45 A this H32 body is doing heavy electrical work, and every milliohm at the terminal turns into heat: 5 mΩ max contact resistance at 45 A is around 10 W sitting at the joint if it is not torqued right. Screw termination is the honest choice at this current because it is inspectable and reworkable in the field without a soldering iron. Rated 250 V AC typical with IP68 sealing, the body suits generator tails, welders and large machine feeds. Torque the screws to spec and recheck after the first thermal cycle.

    Wire gauge and torque on a 45 A contact

    The conductor is half the part number at this current. A 45 A circuit needs a cross section in the 6 mm² and up range, and a barrel or fork lug that matches it, because a thin conductor in a big terminal cooks at the crimp. Insulation resistance is 100 MΩ min and withstand voltage 1500 V AC typical, with an operating window of -40 °C to +105 °C. Inside a junction box the ambient derating starts immediately. Our wire-to-board checklist walks through sizing, and this batch is held to the same records under our ISO 9001:2015 system.

    H32 shell, panel cutout and spares

    The H32 shell is a panel mount power body, so the cutout, the gasket and the mounting hardware belong on the drawing with the contact part number. Five positions at 45 A is a real distribution point, and crews keep spare inserts and screw sets rather than whole connectors. Standard builds leave in eight working days. Send the panel thickness and the conductor spec with the inquiry and we will confirm the thread and the terminal kit. Finished power tails go through our cable assembly line.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products