Products
Products
Contact Us
Home > Circular & Power Connector > IP68 DC Power Socket 5.5×2.1mm Panel Mount with Wi...
M12 Automotive Waterproof Connector — 3 Pin with Cable
  • M12 Automotive Waterproof Connector — 3 Pin with Cable
  • M12 Automotive Waterproof Connector — 3 Pin with Cable
  • M12 Automotive Waterproof Connector — 3 Pin with Cable

M12 Automotive Waterproof Connector — 3 Pin with Cable

Type: M12 automotive connector
Positions: 3 pin
Cable: Included
Sealing: Waterproof
Rated current: 4 A (typical)
Rated voltage: 250 V AC (typical)
Contact resistance: 5 mΩ max
Insulation resistance: 100 MΩ min
Withstand voltage: 1500 V AC (typical)
Operating temperature: -40 °C to +105 °C (typical)

    A three pin automotive drop with the cable already fitted

    Field terminations are where vehicle harnesses leak and fail, so a 3 pin M12 that arrives with the cable fitted takes the worst step out of the install. This waterproof automotive version is rated 4 A typical at 250 V AC typical with 5 mΩ max contact resistance, and three positions cover a supply pair plus a signal or a second supply. The overmold at the back of the shell is the seal, which means the cable length is part of the design rather than something to trim on the bench. Specify the length per drop and the installer only has to plug it in.

    Cable jacket and routing inside a vehicle

    An automotive lead has to survive being pulled through a body opening, tied to a frame rail and left near heat sources, so the jacket choice matters more than the connector color. PVC is fine for cabin runs; ask about a tougher jacket where the lead crosses the engine bay or a moving joint. Insulation resistance is 100 MΩ min and withstand voltage 1500 V AC typical, with an operating range of -40 °C to +105 °C. Our wire-to-board checklist covers the strain relief that keeps the pull off the terminations.

    Ordering leads against a vehicle build schedule

    Vehicle harness orders come in releases tied to build dates, and we quote these pre fitted leads the same way, with lengths, jacket and pin map open while routing is still moving. Custom harness builds of this kind typically leave in 10 to 12 working days. Send the mating connector photo and the routing sketch and we will confirm the overmold and gland before production. The same body in larger runs goes through our cable assembly line with the cable already chosen.

    We are a connector factory in Shenzhen, not a trading middleman, so what you get is factory-direct pricing and an actual engineer looking at your project.

    Standard connectors start at 100 pieces and leave in about 8 business days. Custom parts and harnesses run from 50 pieces. Want to test first? We send free samples of standard items, and for custom work we make a prototype in 1 to 2 days and knock the setup fee off your first order.

    Payment is T/T (50% deposit, 50% before shipping), L/C, PayPal or credit card. Send a drawing, a photo, or just a part number from another brand and we will get back to you with a quote and a free DFM check within a few hours.

    *

    *

    *

    *

Related products