Hongyian Connector

Connector cross-reference: brand part numbers, matched alternatives

If a Molex, TE, JST or Hirose part is costly, slow or tied to a high minimum order, there is often a pin-for-pin alternative made in our Shenzhen factory. This page is the working index of everything we have published on the subject: brand cross-references, series comparisons and selection guides — 39 guides in all. Each one lists the pitch, pin count, current rating and housing details you need to check before switching.

Send us a part numberBrowse the index

Why buyers switch from the original brand

100 pcsstandard equivalents, low MOQ
1–2 dayssamples for most series
8–12 dayscustom production lead time
3–5 daysemergency first batch

We keep the mating geometry the same and change only what does not affect fit: the supplier. Every comparison is checked against the original drawing before we quote. If a part cannot be matched safely, we say so rather than force a substitute.

Cross-reference index by original brand

Series comparisons: A vs B

When the question is not "what replaces this part" but "which family does my design need", these comparisons line up two series side by side — pitch, current, locking, wire size and typical applications.

Selection guides and ordering reference

How we confirm a drop-in replacement

1. Match the geometry

Pitch, row count, pin map, mounting style and mating housing are checked against the original part drawing.

2. Match the electrical spec

Current rating, voltage, contact plating and housing material are compared side by side.

3. Prove it with a sample

We send a sample and the comparison sheet. You test it on your board or harness before ordering.

Questions buyers ask

What does cross-reference mean for a connector?

It means matching the original part number to a connector with the same pitch, pin count, contact layout, current rating and housing footprint, so it fits an existing PCB or harness without redesign.

Can you replace Molex or TE connectors with a lower MOQ?

Yes. Common Molex KK 254, Mini-Fit Jr and TE MATE-N-LOK equivalents start at 100 pieces. Custom versions can start from 50–100 pieces, with samples in 1–2 days.

How do I know an alternative is really compatible?

Send the original part number and a photo of the mating housing. We check pitch, pin map, current and material, then send a side-by-side sheet and a sample before any production order.

JST XH or Molex KK 254 — which 2.54mm series should I specify?

Both are 2.54mm wire-to-board families, but they are not drop-in interchangeable. XH uses a positive lock and is rated around 3A; KK 254 uses a friction lock and covers roughly 4A depending on circuit size. If the board already carries one footprint, stay with it.

Where can I find drop-in equivalents for Molex Mini-Fit Jr part numbers?

Start with the Mini-Fit Jr 4.2mm guide in the Molex section above. It decodes 5557, 5559 and 39-01-2xxx part numbers and lists factory-direct equivalents with the same footprint and current ratings up to 9A, available from 100 pieces.